Image
Product
Price
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Cylinder Head to Y-pipe
Additional Fitment Information:
| Vehicle |
|---|
| 1990 - Subaru Legacy |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Cylinder Head to Y-pipe
Additional Fitment Information:
| Vehicle |
|---|
| 1990 - Subaru Legacy |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- This engine does not use a gasket between the oil pan and the block, except for this o-ring located in the right rear corner of the oil pan. Use the appropriate liquid gasket sealant to seal the joint along the perimeter of the oil pan.
Additional Fitment Information:
| Vehicle |
|---|
| 1990 - Subaru Legacy |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Cylinder Head
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 1990 - Subaru Legacy | Rear |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle |
|---|
| 1990 - Subaru Justy |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle |
|---|
| 1990 - Subaru Legacy |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Cylinder Head to Y-pipe
Additional Fitment Information:
| Vehicle |
|---|
| 1990 - Subaru Legacy |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- 25.5 x 20 x 2.5
Additional Fitment Information:
| Vehicle |
|---|
| 1990 - Subaru XT |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Outside of the Bearing Carrier (There are two Inner Seals)
Additional Fitment Information:
| Vehicle | Position | Drive Type |
|---|---|---|
| 1990 - Subaru XT | Rear Inner | 4WD |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- 23.7x3.5mm O-Ring
Additional Fitment Information:
| Vehicle |
|---|
| 1990 - Subaru Legacy |
Showing 1 - 10 of 22 products
Loading...