2008 Subaru Legacy Engine Oil Pan Gasket Parts

Choose your Engine for your 2008 Subaru Legacy


Showing 1 - 2 of 2 products
Image
SKU
Product
Rating
Price

Nippon Reinz
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • O-Rings along the front of Oil Pan
  • 19.2 x 2.4mm O-Ring (Between Crankcase Halves)

Additional Fitment Information:
Vehicle Block CC Position Engine CID
2008 - Subaru Legacy H 3000 Upper 6 Cyl 3.0L -

Nippon Reinz
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • This engine does not use a gasket between the oil pan and the block, except for this o-ring located in the right rear corner of the oil pan. Use the appropriate liquid gasket sealant to seal the joint along the perimeter of the oil pan.

Additional Fitment Information:
Vehicle Block CC Position Engine CID
2008 - Subaru Legacy H 2458 Lower 4 Cyl 2.5L -
Showing 1 - 2 of 2 products

Loading...