1990 Ford Bronco II Alignment Caster / Camber Bushing - Front Upper Specialty Products
- These popular sleeves are widely used to adjust caster and/ or camber on many Ford and Mazda RWD & 4WD trucks. To install, simply loosen and remove upper ball joint pinch bolt. Remove top snap ring if one is present. Use 77880 or 88830 sleeve puller to remove the existing sleeve. To split camber and caster adjustment, rotate sleeve 45°. Save time during alignment, use 23199 zero degree sleeve to determine initial readings, then install correct sleeve. Note: Sleeves adjust to a smaller degree on Ford andMazda 4WD light trucks/SUVS.
Additional Fitment Information:
| Vehicle | Position | Drive Type |
|---|---|---|
| 1990 Ford Bronco II | Front Upper | RWD |
- FREE SHIPPING on order over $100 USD shipped from same warehouse
- FULL WARRANTY
-
Order 24/7Order online anytime
-
100% SafetyOnly secure payments
-
Hot OffersDiscounts up to 90%
General
California Proposition 65
Warning: This Product Contains Chemicals Known To The State Of California To Cause Cancer, Birth Defects, Or Other Reproductive Harm.
Packaging
package quantity
1
weight
0.38 lb
Information on technical characteristics, the delivery set, the country of manufacture and the appearance
of the goods is for reference only and is based on the latest information available at the time of publication.
Related Products
Loading...